Pompano Beach FL Electrician & AC Repair

Heat pump installation

1)——Supply and replace 3 120 volt landscape spot lights with 90 watt equivalent LED bulbs. 2)——Remove all photocells controlling ground lights. 3)——Install 120 volt 5 pole lighting contactor and time clock next to landscape lighting panel. 4)——Rewire landscape lighting circuits to operate off of timer and lighting contactor. 5)——Repair improper grounding in circuit panel.

Supply and install (2) LED 100W lights Install new fan motor on 7.5 ton package unit on roof Lift required for lights

Remove and discard existing equipment Install new 3,5 ton American Standard 14 seer package unit. 1 year Red Carpet club. 10 years warranty for parts and 1 year warranty for labor.

REPAIRED NON-COOLING AC UNIT Evacuate refrigerant and remove the failed compressor. Install new compressor. Recharged refrigerant up to manufacture designed specs. Cooling to specs

1)----Remove GFI at DISHWASHER/DISPOSAL and replace with half switched outlet. 2)----Install customer supplied 1/2 switched outlet and switch in master bedroom. 3)----Remove 2 switches in master bathroom and replace with night light and customer supplied switch.

Repaired landscape lights

AC maintenance: - Freon pressure checked. - belt tension is checked

AC maintenance: - replace (4) filters - check Freon pressure. - check and adjust belt tension

TEST

Replace two switches. Remove transmitter from fan.

Dedicate line for new outlet in garage, underneath the panel. Drill the hole through concrete wall for camera cables

Remove existing roof top package air conditioning unit and replace with new Carrier 5-Ton, 14 SEER package unit. Includes factory 5 year warranty. Furnish and install new motorized damper per code. Existing electric and duct work to remain. Furnish crane to hoist unit to roof and remove old unit. Remove and discard old unit form site. Permits are optional at $500.00

Convert a total of 19 metal hi bays to LED Replace bulbs and or ballast or both for 12 4 bulb flourecents 1 year warranty with all work

1)-----Remove and replace 1 T12 8 ft flourescent ballast. 2)----Remove and replace 3 T12 8 ft flourescent bulbs.

Install (2) hi hats trims Install (2) outdoor fixtures

1)-----Remove and replace bathroom switch.

1)-----Remove ballasts at 2 parking lot pole lights and wire fixtures to line voltage. 2)-----Supply and install 400 watt equivalent LED bulbs at both fixtures. 3)-----Remove 3 metal halide wall packs and replace with 250 watt equivalent LED wall packs. 4)-----Reconfigure photocell circuit and replace photocell. NOTE: THERE WILL BE ADDTINAL CHARGES FOR BUCKET TRUCK.

Replace bathroom gfci

1)-----Install 2 8 ft galvanized ground rods. 2)-----Install 1 low voltage ground bridge. 3)-----Install 1 water pipe ground clamp. 4)----Connect all points using #4 gauge bare copper wire back to main breaker panel.

Install smart thermostat, 4 wires

Hardwire battery charger for forklift where existing charger located

Diagnosis level 2 Bathroom lights and outlets not working probably 1 outlet in kitchen not working

Upgrade indoor and outdoor panel to 125 amps panels Replace 5ft of feeders to bigger wires

Move 1 tripple gang switch box to opposite side of wall. Remove 1 tripple gang switch box and relocate around corner with a 2 gang with one stack switch and one dimmer switch.