Pompano Beach FL Electrician & AC Repair

Diagnostic on switch by front door not working

Customer has (2) emt pipes that are connecting to junction box where old wall used to be. Customer would like to move outlet and switch to new wall location on drywall. Customer has garbage disposal/dishwasher outlet that isn’t working properly. Switch isn’t shutting off either outlet Customer is also getting tankless hot water heater and needs additional power Work is as followed; Kitchen remodel Remove existing pipe that is currently going down to hanging switch/outlet box. Install new pipe and land inside a junction box in ceiling. Install (2) seperate Romex circuits from new Jbox to desired location Cut in new 2G plastic box for new outlet and switch Diagnose and repair problem with outlet underneath sink. Outlet is constantly hot and not turning on and off with switch

Replace (2 dimmers Replace (2) switches Test outside landscape Change (1) ballast

Bedroom circuit isn’t working Entire room is out Need to trace back where problem may be stemming from Found issue on switch for fan in bedroom. Screw was hitting metal box causing short

Supply and install new 2.5 ton Rheem split system AH is a shorty above Water heater Permit needed Crane needed. 10 year manufacturers warranty on all parts 1 year labor warranty with Kings 1 year (3) times a year ac maintenance program with Kings Water heater install underneath AC Permit included for water heater Water heater supplied by us

Add up to 3lbs Freon 410a

Add up to 3lbs Freon 410a

Replace compromised time clock for hot water heater with new time clock.

Remove old air conditioning system with new 3-ton high efficiency system.

Repairs made to air conditioning system installed by others. misc. repairs to pass inspection.

Remove old air conditioning system with new 3-ton high efficiency system.

After the Fact permit for air conditioning system installed by others.

Replace meter can and replace Aluminum Wire

1) Remove 100 amp main breaker disconnect and 50 amp GFI disconnect. 2) Install new 100 amp main breaker disconnect. 3) Update grounding system: Install 2 new ground rods, 1 water pipe ground and low voltage ground bridge interconnected with #6 gauge bare copper wire.

Clear drain line and suck out water in ah pan

Replace pancake air Handler in unit and condenser on roof.

1) Remove and replace 30 circuit 200 amp 3 phase GE main lug panel for unit 7961. 2) Remove and replace 200 amp 3 phase fused main disconnect for unit 7915.

Replace bulb on patio Install new 110 volt smoke detector Remove existing ballast from bathroom fluorescent and install new ballast

Common Problems:OTHER:See Notes Replace smokes with heat detectors. Call Lauren

Electrician ran new circuit from outside sub panel that was double tapped to main panel outside.

Licensed electrician installed approximately 77 alumicons and tamper proof receptacles.

Electrician replaced 2 bulb fluorescent ballast.

Licensed electrical service technicians assembled and installed 6 ceiling fans and 2 pendant lights.

Licensed electrical service technician installed a ceiling fan and rocker switch.

Remove and replace bad meter blocks.