Local Electrician | Broward, Palm Beach, Orange County and Seminole Counties

Install new line for hot water heater Install new breaker 25amp Hardwire hot water heater

Dryer outlet is not working Patio fan doesn’t have power Ceiling fan in bedroom isn’t working (1) outlet in bedroom not working properly Replace 2 outlet in bathrooms to GFI Diagnosis (1) outlet not working in another bathroom.

1)-----Run 2 cat5 Ethernet lines from upstairs loft area to office and guest bedroom. (Approximately 30-40 ft.) 2)-----Install low voltage cut in ring in loft area with double cat5 outlet and cover plate. 3)-----Install low voltage cut in ring in office and guest bedroom with single cat5 outlet and cover plate in each room. 4)-----Supply cat5 Ethernet cord.

Found that salternator required service. Has full power at pool. Also wants to replace 20 halogen bulbs

Supply and install outlet on half wall Supply and install (2) dimmer switches

Diagnosis level 2 Outlets in kitchen not working probably Outlets in front lab not working

3 visits

Replace (1) under cabinet light in kitchen (including light (1) light bulb) Replace (1) smoke detector in hallway

1)-----Remove exisitng flood light from left front corner of home. 2)-----Replace with new 2 Headed motion detected LED flood light.

Supply and install new 200amp indoor panel Supply and install new outside 200amp meter main combo panel Permit fees additional $500.00

OUTDOOR- 1)-----Remove Challenger 200 amp outdoor main breaker circuit panel. 2)-----Replace with new GE 200 amp outdoor 8/16 circuit main breaker feed thru panel. 3)-----Update grounding system: includes 2 ground rods, 1 water pipe ground and 1 low voltage ground bridge interconnected with #4 gauge bare copper wire. 4)-----Label panel and clean area. INDOOR- 1)-----Remove Challenger 200 amp indoor 30 circuit main lug panel. 2)-----Replace with new GE 200 amp indoor 20/40 circuit main lug panel. 3)-----Label, rough patch and clean.

Diagnostic and repair on front door circuit

Lost power 3 bathrooms and garage

Supply and install new switch

Install customer supplied fan

Supply and install new 220V line for dryer approximately 25ft Install new outlet for 220V Hook up new dryer

Light bulbs replaced

OUTDOOR OUTLETS/KITCHEN OUTLETS/GARAGE OUTLET- 1)-----Remove 6 outdoor outlets and cover plates. 2)-----Replace with new GFI outlets and in use bubble covers. 3)-----Troubleshoot circuit to find why the circuit is working intermittently. 4)-----Remove 4 kitchen outlets and replace with GFI outlets. 5)-----Remove garage GFI outlet and replace with new GFI outlet. COST:$1619.45 WATER HEATER/GENERAL LIGHTING CIRCUIT- 1)-----Remove and replace 20 amp water heater breaker. 2)-----Remove and replace 15 amp general lighting circuit. COST:$417.95

Supply and install (9) GFCIs in home and around home (2) in bathrooms (2) in kitchen by sink (2) in kitchen by appliances (3) outside with bubble covers Ivory Tenantitely scheduled for weds July 11th. 8am

1)-----Disconnect pool heater whip from disconnect box. 2)-----Confirmed that grounding of pool is proper and correct. NOTE: Advised customer that if more proof of pool grounding is necessary, they may inquire the city about approved and permitted drawings of pool that should show grounding system.

Clean clogged drain line

THERMOSTAT- 1)-----Remove exisitng thermostat in guest bedroom. 2)-----Relocate thermostat wiring to hallway. 3)-----Reinstall exisitng thermostat. KITCHEN WALL- 1)-----Remove any wires deemed not necessary. 2)-----Install exisitng receptacle circuit into junction box in new wall. 3)-----Install GFI outlet. 4)-----Extend circuit from GFI outlet to below GFI. 5)-----Install junction and outlet below GFI. 6)-----Trace out circuits to light switches and connect so that they function properly. 7)-----Reinstall all boxes hanging out of wall.

Replace existing air conditioning system with a new American Standard high efficiency system. 10 year factory warranty on parts. Install air handler in the attic horizontally with new auxiliary drain pan and safety switch for drain system. Flush out drain lines. Vacuum pump system before start up. New supply and return plenum., up-size return flex duct @ 3.5 ton system

1)-----Extend circuit from exisitng switch box by garage side door to the right of switch box. 2)-----Install new switch box. 3)-----Run switch line from new switch box to desired location of light to be installed above washer and dryer. 4)-----Install junction box in ceiling. 5)-----Supply and install 4ft LED fixture at junction box.

Supply and install (1) whole house surge protector