Local Electrician | Broward, Palm Beach, Orange County and Seminole Counties

RCC AC maintenance visit Issue with outlet was due to lamp.

Diagnosis and repair outside outlets not working properly

Supply and install new pool transformer Supply and install new slide dimmer

Replace (2) ballast T12 4FT

1)-----Remove 12 exisitng hihat bulbs and trims. 2)-----Supply and install 12 HALO brand LED retro fit trims. 3)-----Rent lift and have delivered to property. 4)-----Remove outdoor fan down rod and canopy on back porch. 5)------Remove outdoor fixture on back porch. 6)------Install 2 customer supplied fixtures.

1)-----Run 1 inch pvc conduit from main breaker outdoor circuit panel to desired location of spa disconnect on patio. (Approximately 40-50 ft.) 2)-----Pull 4 wire 60 amp 240 volt circuit thru conduit and install 60 amp breaker at panel. 3)-----Install 60 amp spa disconnect with GFI breaker on patio. 4)-----Run 1 inch pvc and flexible conduit from spa disconnect with 60 amp circuit to hot tub and connect to motor control center. 5)-----Power up hot tub.

GARAGE OUTLET- 1)-----Extend circuit using 1/2 inch pvc from exisitng electric in garage to desired location less than 5 ft. 2)-----Install 2 gang outlet box. 3)-----Install 1 weather resistant 15 amp GFI outlet and 1 standard weather resistant duplex outlet with industrial cover plate at 2 gang box.

1)-----Run 1/2 inch pvc conduit from outdoor main breaker circuit to desired location close to pond/pump approximately 100 ft. (Will have to trench 15-20 ft 16 inches deep from pool deck to desired outlet location) 2)-----Pull 20 amp circuit thru 1/2 inch conduit. 3)------Remove 30 amp breaker and supply/install 30/20 amp quad breaker at outdoor panel. 4)-----Install brace and 2 gang weather proof box at pond. 5)------Install 1-20 amp weather resistant GFI receptacle and 1-20 amp weather resistant standard duplex receptacle with weather resistant in use bubble cover. 6)-----Terminate circuit and power up.

Diagnostic on one outlet not working Found (2) tripped breakers

Gave estimate for new line for sconce

1)------Remove 125 amp main breaker. 2)-----Replace with new 125 amp GE main breaker. 3)-----Remove 3 prong dryer outlet and cord. 4)-----Replace with new 4 prong dryer outlet and cord.

Diagnosis and repair minor electric misc

Drop (2) new 6” flex duct, 18ft/each. Seal the opened ductwork.

Supply and install 2OT copper x3 from inside panel to outside panel Existing wiring is aluminum. Copper holds a much better conductivity for the panel Run is approximately 70-80ft

Supply and install decora white switch Found old switch to have burned out cause breaker to trip Panel is also quite old. May look into replacing soon

1)-----Remove digital timer for landscape lights. 2)-----Install photocell for landscape lights.

1)-----Remove 2 exisitng puck lights. 2)-----Install 2 customer supplied puck lights. 3)-----Modify one puck light to extend wire so that it reaches transformer plug.

Recommend system upgrades

Supply and install outlet for garage door opener Found loose neutral in attic which went to living room lighting.

Install customer supplied porch light

Add (1) oven outlet where existing outlet located Replace (1) 2 pole 30 amp breaker for water heater

Wire losing connection at j-box

Put two wires back on breaker

Troubleshoot range circuit- 1)------Opened up outlet and found there was no apparent defects and all connections were tight. 2)-----Checked breaker and line. All connections were tight at breaker and was functioning properly. Line was in good condition. NOTE: More than likely the damage was caused by water damage from the roof leak caused by the hurricane.

Troubleshoot possible bad light switch. Remove bad and install new single pole stacked toggle switch.