Tamarac FL Electrician & AC Repair

Hook up Cubicle

Clear drain line clogged causing no power to nest thermostat

Supply and install 30 amp generator outlet below the outdoor panel

1)——Run dedicated 20amp small appliance cirucit from panel to 2 locations on kitchen counter top location. 2)——Install new 20 amp GFI and 20 amp standard outlet with cover plates. 3)——Run dedicated 20 amp small appliance cirucit from panel to dining room outlet location. 4)——Install new 20 amp standard outlet. 5)——Remove Approximately 45 devices including; Standard outlets, GFIs , switches and dimmers. 6)——Convert all wiring at devices to copper using alumicon connectors and install new devices at each location. 7)——Repair burnt wiring in master bedroom.

1)——Remove outdoor 150 amp main breaker panel and double tapped sprinkler sub panel. 2)——Install junction box at main feeder conduit going into indoor panel and extend feeder wires to right side of meter so panel can be installed properly. (No room for panel installation on left side of meter) 3)——Install 150 amp outdoor 8/16 circuit main breaker panel. 4)——Reroute sprinkler and general outlet circuit into new main breaker panel. 5)——Update Grounding: Install 2 new ground rods, 1 water pipe ground and 1 low voltage ground bridge interconnected with #4 gauge bare copper wire. 6)——Install whole home surge protector. 7)——Remove indoor 150 amp main lug circuit panel. 8)——Install new 150 amp indoor main lug 40 circuit panel. 9)——Extend all aluminum circuits with copper wire using alumicon connectors. (Approximately 38 wires) 10)——Label both panels, rough patch and clean area.

Install customer supplied ceiling fan. Install 5 customer supplied exterior wall sconces.

Remove existing outlet box and move over 6 in and install new cut in box with cover plate

1)——Troubleshoot AC compressor circuit to find electrical issue. FOUND: Short circuit at disconnect and bad disconnect. 2)——Remove disconnect and cut flexible conduit back to get enough good wire to connect to new disconnect. 3)——Install new 60 amp non fusible pull out disconnect.

1)——Remove post light fixture. 2)——Supply and install new post light fixture. 3)——Replace photocell.

Replace GFI outlet in kitchen and repair kitchen light

Dropped off permit

Dropped off permit

Dropped off permit

Dropped off permit

Dropped off permit

Dropped off permit

Replace (2) customer supplied ceiling fan In (1) new UL ceiling amp box Replace (1) fixture customer supplied

Ceiling fan installation

Replaced bathroom overhead light with brighter LED light fixture. Removed box around old light

Replace existing obsolete electrical panel with new code compliant circuit breaker panel. Correct single strand aluminum wires, to comply with inspection. Permits and inspections included.

Remove exisitng light fixtures from stairwells. Supply and Install 8 ceiling mount 100 watt equivalent LED fixtures. Supply and install 100 watt equivalent wall packs.

Replace indoor panel Run a dedicated circuit from panel to microwave Run a dedicated circuit from panel to TV on same wall

Supply and install (1) condensate pump

Replace (1) GFCI outlet Install new bubble cover

Supply and install new outdoor outlet