Tamarac FL Electrician & AC Repair

Remove broken bulb

Diagnosis GFCI outlet tripped and (1) GFCI outlet not working Install (2) bubble cover

Replace (1) fluorescent 2x4 by LED panel customer supplied

Disposal replacement

Install (2) customer supplied chandeliers. Ceiling is 10ft high

Replace (1) thermostat Clean drain line Recommend replace (1) 20x20x1 air filter and clean evaporator coils

Pool pump not working

1)——Go through 3 air compressor circuits and diagnose problem. FOUND: Bad line to FPL causing issues with 2 compressors and the other compressor motor starter needs to be replaced.

KITCHEN- 1)——Run dedicated 20 amp fridge circuit(approximately 25ft)from panel to desired location of fridge and install 20 amp single outlet with cover plate. 2)——Run dedicated 3 wire small appliance circuit(approximately 25ft)that will supply 2 circuits to 2 locations at counter top. 3)——Supply and install 2 20 amp GFI outlets at counter top and 1 20 amp GFI outlet under sink. RECEPTION AREA- 1)——Remove 4 ft fluorescent fixture. 2)——Reroute existing switch line to 4 locations. 3)——Supply and install 4 6 inch round LED remodel fixtures. 4)——Remove 2 exit signs and 1 emergency light. 5)——Supply and install 1 LED emergency light/exit sign combo with battery back up. MACHINE CIRCUIT- 1)——Run dedicated 20 amp machine circuit(approximately 50ft)from panel to desired location of machine and install single 20 amp outlet with cover plate. VARIOUS EXIT SIGNS AND EMERGENCY LIGHTS- 1)——Remove 2 emergency lights and supply/install 2 LED emergen

Replace (4) Outdoor Landscape lights.

Replace (2) Outdoor Landscape lights.

Diagnose issue with AC not working. Found that condenser unit on roof was struck by lighting and caused major electrical damage to unit. All internal parts inside the unit we're damaged, including the compressor. Replace existing 3.0 Ton compromised system with a new 3.0 ton, high efficiency system.

1)——Remove dining room fixture and install customer supplied fixture. 2)——Remove hall fixture and install customer supplied fixture.

1)——Remove garage GFI and replace with new weather resistant GFI outlet. 2)——Remove 3 outdoor outlets and cover plates and replace with new weather resistant outlets and weather proof bubble covers. 3)——Caulk around outdoor outlets to seal covers.

Diagnosis level 1 (3) 1 year Ac red carpet club with 3 visits/year Install (1) AC whips for air handler

1)——Check all switches and outlets newly installed by owner and ensure they are done correctly. (Approximately 14 devices) 2)——Remove and replace all old switches and outlets downstairs with new customer supplied switches and outlets. (Approximately 17 devices) 3)——Install customer supplied light fixture in kitchen.

Diagnosis stove breaker tripping. Found: losing wires at terminal block. Fixed it temporarily by tapping with electrical tape, customer must replace terminal block as soon as possible

Replace (1) T12 U shape ballast Replace (3) T12 fluorescent bulbs in chapel room, 16ft high (ballast is not included) Change (3) light bulbs Inspect (1) landscape light in front

Diagnosis water condensation Not from AC drain line

Diagnosis and fix fans patio not working properly. Not including replace wire being interrupted inside the conduit or the units are broken.

Switch in bathroom not working Switch in dining room not working

1)——Remove bad outlet and wiring at hot water heater. 2)——Hardwire hot water heater to water heater circuit.

1)——Replace twin 20 amp breaker.

1)——Supply and Install Approximately 30 alumicons attached to all single strand aluminum circuits at indoor circuit panel. 2)——Install alumicons at all single strand aluminum wired devices.(23 devices)

1)——Run dedicated 15 amp circuit from panel to 4 locations. (By garage entry door, inside each bedroom and outside each bedroom.) 2)—-Install junction box and and hardwired smoke detectors with 10 year lithium battery back up at each location.(Garage entry door will require carbon/smoke combo)