Sunrise FL Electrician & AC Repair

Install (1) motion light Install one back to back outlet Install one outlet in garage for garage door Install one box and sconce light outside

Complete new panel install

Supply and install new 125 amp indoor electrical circuit breaker panel

Install dedicated 20amp circuit for stove Install dedicated 20amp circuit for microwave Install dedicated 20amp circuit for GFCI in kitchen Diagnose and repair out kitchen lighting issue.

Repair microwave circuit

1)-----Remove 2 exsitng garage light fixtures. 2)-----Remove conduit and junction box where one fixture was. 3)-----Extend circuit from exsitng junction box. 4)-----Install junction box for outlet. 5)-----Install outlet and cover plate.

Supply and install (4) T12 40 fluorescent bulbs. Repair (1) fixture broken

Supply and install (4) T12 40 fluorescent bulbs. Repair (1) fixture broken

1)-----Remove exsitng pool light wiring and transformer. 2)-----Run new switch line from exisitng power source in kitchen to exterior location and install outdoor weather proof junction box. 3)-----Extend switch line from outdoor junction box to location where new transformer is to be installed. 4)-----Install new 100 watt pool light transformer and connect switch line. NOTE: BONDING AND GROUNDING IS NOW SUFFICIENT AFTER REPAIRS.

1)-----Disconnect desired cubicle. 2)-----Reconnect desired cubicle.

1)-----Disconnect desired cubicle. 2)-----Reconnect desired cubicle.

Disconnect cubicles.

1)-----Remove 4 outlets in kitchen. 2)-----Replace with new GFI outlets and cover plates. 3)-----Remove and replace 2 outlets in dining room. 4)-----Remove 2 rotary dimmers. (Dining room and living room) 5)-----Replace with new LED rated dimmers. 6)-----Remove and replace doorbell button, chime and transformer. 7)-----Remove porch light and replace with new customer supplied light.

Diagnosis GFI is not working

1)-----Remove and replace 3 T8 3 bulb 4ft flourescent ballasts.

1)-----Extend circuit from exisitng interior outlet on west side of home to exterior wall. 2)-----Install 2 gang weather proof junction box. 3)-----Install weather resistant 15 amp GFI and standard outlet. 4)-----Install weather proof in use bubble cover.

1)-----Remove indoor 150 amp main lug CHALLENGER BRAND circuit panel due NON UL listed equipment and safety issues with the CHALLENGER BRAND. 2)-----Replace with indoor 150 amp main lug 20/40 circuit GE brand circuit panel. 3)-----Label, rough patch and clean. 4)-----Remove 150 amp outdoor main breaker enclosure. 5)-----Replace with new 8/16 circuit outdoor main breaker feed thru panel. 6)----Clean area.

Install ceiling fan and switch

1) Remove and replace switch in dining room. NOTE: Switch in hallway was connected to feed in dining room.

Remove double tapping and add (2) GE 20amp breakers

Remove double tapping and add (2) GE 20amp breakers

1) Remove A/C disconnect. 2) Remove exisitng power supply rubber flex and low voltage thermostat rubber flex. 3) Install new non fused pullout A/C disconnect. 4) Run new rubber flex and feeders from disconnect to A/C condenser. 5) Run new rubber flex for thermostat wiring. 6) Disconnect wiring from time clock to sprinkler. 7) Remove exisitng rubber flex for sprinkler. 8) Install new rubber flex from sprinkler timer to sprinkler.

Warranty work arc fault tripping When roof was done , roofers put a nail through wiring in ceiling which is in accesible

1) Remove all 110 volt outlets, switches and cover plates. 2) Replace with new standard tamper resistant duplex receptacles and switches with new cover plates.

Replace receptacle