Miami FL Electrician & AC Repair Service

Electrical repairs at marina due to storm damage. Replace damaged wire from shore power pedestals to meter center. Make misc repairs to pedestals.

OUTDOOR- 1) Remove 100 amp meter enclosure and riser with service feeder wires. 2) Install new 200 amp meter enclosure at new location approximately 15 feet to the left of original location. (Original location is a code violation due to clearance and feeder wires being to close to the ground and not out of harms reach) 3) Install 2 inch rigid riser with new 2/0 gauge copper feeders at meter enclosure. 4) Install outdoor 200 amp 8/16 feed-thru main breaker panel. 5) Run new 2 inch pvc conduit from 200 amp main breaker panel to indoor circuit panel. (Approximately 30-40 ft) 6) Pull 2/0 gauge copper feeders from main panel to indoor circuit panel. 7) Install new grounding system: 2 ground rods, 1 water pipe ground and 1 low voltage ground bridge all interconnected by #4 gauge bare copper wire. INDOOR- 1) Remove 100 amp main lug panel. 2) Install new 200 amp main lug 20/40 circuit panel. 3) Label, rough patch and clean. 4) Replace all necessary devices throughout home and refur

Install customer supplied fixture on 16' ceiling. Provide scaffolding. Relocate lighting outlet with wiremold raceway per code.

Fix issue with double tapping at main electrical panel in order to bring panel up to code for insurance policies. Office will mail credit of $430.30

1) Remove GFI outlet in kitchen. 2) Replace with new GFI outlet. 3) Go through all outlets on GFI circuit in kitchen and make sure all connections are tight and voltage is correct. 4) Remove and replace GFI outlet in guest bathroom. 5) Remove and replace double switch in master bathroom.

Diagnose / troubleshoot electrical issue with voltage fluctuations at dock pedestals.

Diagnose / troubleshoot electrical issue with voltage fluctuations at dock pedestals.

Hang customer supplied hug fixtures next to refrigerator

Remove existing fixture and install (3) new 4 inch recessed fixtures Remove existing kitchen fixture and replace with 2 foot led fixture with led bulbs Remove existing living room fixture and replace with customer supplied standard surface mount fixture

Paid CC # 5749 PULL PERMIT ON EXISTING WORK AND GET INSPECTION. ANY ADDITIONAL REQUIREMENTS BY CITY WILL BE CHARGED ACCORDINGLY. TOTAL= $750.00 -59.95 (Dispatch already paid) = $690.05 balance 100.00

1) Install customer supplied fixture in kitchen 2) Troubleshoot disposal

Uninstall fixture installed by handy man

Hang customer supplied fixture

Lights flickering

Installation:Add new fixtures:Already Sold Balance $925.00 Hang fixture 12-14" Ceiling

Electrician installed a customer supplied ceiling fan.

Installed special-ordered exhaust fan in apartment.

Replaced main 150-amp circuit breaker.

Supply and install new 20 amp GFI receptacle in master bedroom.

Replace electrical panel