Miami FL Electrician & AC Repair Service

Recommend: AC disconnect replacement

1)----Remove existing stairwell light fixture. 2)----Remove hihat at stairwell. 3)----Install proper fixture hanging junction box. 4)----Reinstall stairwell light fixture.

1)----Troubleshoot livingroom outlet and back to back outdoor outlet. 2)----Remove faulty install of outdoor outlet and bad indoor living room outlet. 3)----Install new weather proof outdoor box with GFI outlet and in use weather proof bubble cover. 4)----Install new outlet amd cover plate in living room.

1) Remove 15 outdoor patio lights. Demo and prepare areas for install. 2) Install 6 pancake boxes at post light locations. 4) Run switch leg throughout circuit to 15 locations through exisitng conduit. 6) Supply and install 15 outdoor LED patio lights.

Replace (1) capacitor

Pool pump not working

Repair On-Shore Power riser Supply and install (1) 50amp Supply and install (1) 30amp Supply and install (1) 20amp

Install underground conduit and wire for customer supplied pool heater. Connect to new sub-panel. Provide 50-amp, 240-volt, dedicated GFCI circuit Trenching and backfill is included.

Install underground conduit and wire for customer supplied pool heater. Connect to new sub-panel. Provide 50-amp, 240-volt, dedicated GFCI circuit Trenching and backfill is included.

Install underground conduit and wire for customer supplied pool heater. Connect to new sub-panel. Provide 50-amp, 240-volt, dedicated GFCI circuit Trenching and backfill is included.

Install underground conduit and wire for customer supplied pool heater. Connect to new sub-panel. Provide 50-amp, 240-volt, dedicated GFCI circuit Trenching and backfill is included.

Install underground conduit and wire for customer supplied pool heater. Connect to new sub-panel. Provide 50-amp, 240-volt, dedicated GFCI circuit Trenching and backfill is included.

Install underground conduit and wire for customer supplied pool heater. Connect to new sub-panel. Provide 50-amp, 240-volt, dedicated GFCI circuit Trenching and backfill is included.

Install underground conduit and wire for customer supplied pool heater. Connect to new sub-panel. Provide 50-amp, 240-volt, dedicated GFCI circuit Trenching and backfill is included.

Install underground conduit and wire for customer supplied pool heater. Connect to new sub-panel. Provide 50-amp, 240-volt, dedicated GFCI circuit Trenching and backfill is included.

Install underground conduit and wire for customer supplied pool heater. Connect to new sub-panel. Provide 50-amp, 240-volt, dedicated GFCI circuit Trenching and backfill is included.

Install underground conduit and wire for customer supplied pool heater. Connect to new sub-panel. Provide 50-amp, 240-volt, dedicated GFCI circuit Trenching and backfill is included.

Install underground conduit and wire for customer supplied pool heater. Connect to new sub-panel. Provide 50-amp, 240-volt, dedicated GFCI circuit Trenching and backfill is included.

Panel Install

Boat owner unable to get electric power at pedestal. Breaker is rusted out on dock side pedestal.

1)-----Set outlets in kitchen so they aren't loose. 2)-----Check outlet in kitchen that caused breaker to trip and make sure they're are no defects. 3)-----Troubleshoot dishwasher and disposal outlet and replace if necessary. 4)-----Set outlet in bedroom so it isn't loose. 5)-----Remove wiring and switch from washer circuit. 6)-----Check and confirm correct voltage on water heater circuit.

Convert stack switch and outlet to separate GFI outlet and switch

Rail road inspection

OBSERVATIONS: 1)-----The main breaker panel has been compromised and will need to be replaced for FPL restore power. 2)-----There is no ground system and will also need to be updated. NOTE: These things are the bare necessity to get power. There are a number of other issues that need to be addressed but cannot be inspected without power. After the panel is replace we will check power and assess the other issues to give a better idea on what the additional repairs will be and cost.

PATIENT ROOMS- 1)-----Locate and extend emergency circuits in 4 patient rooms to desired locations of emergency outlets to be installed.(approximately 10-20ft per circuit) 2)-----Install junction boxes at each circuit extension for a total of 4. 3)-----Install 2 emergency outlets in each patient room for a total of 20 outlets. 4)-----Fasten all loose devices and remodel junction boxes back to original positions with cover plates. WAITING ROOMS/LOUNGE AREA- 1)-----Extend circuit from exisitng outlet to desired location of tv and install junction box with outlet. 2)-----Install cable outlet at same location of tv. 3)-----Remove old tv outlet and locate where circuit is coming from to extend circuit and relocate outlet with GFI to position just beneath old tv outlet for coffee maker. 4)-----Run 3 dedicated 20 amp circuits from main panel to desired locations of each device: Approximately 90 ft per circuit(2 freezers and 1 i