Hollywood FL Electrician & AC Repair

Disconnect power from 3 cubicles. Re-Install at different location Disconnect power from 3 cubicles. Re-Install at different location

1)——Remove existing cook top and disconnect from power. 2)——Install new cook top and hardwire to existing power. 3)——Remove 2 fluorescent fixtures in closet. 4)——Install 2 4ft customer supplied LED fixtures in closet.

GFI not working

1)——Remove 4 flourescent fixtures in kitchen. 2)——Replace with 4 4ft LED fixtures.

Clean (7) supply and (1) return AC ducts. Remove and clean grills.

Repair rusted FPL pipe with PVC , Sealant , and metal straps

1)-----Extend circuit from exisitng power to 1st location of carbon smoke in master bedroom. 2)-----Loop circuit to 4 other locations: Hall, guest bedroom 1, guest bedroom 2 and outside of guest bedroom 2. 3)-----Install remodel cut in box at each location. 4)-----Supply and install 5 hardwired and interconnected carbon/smoke detector combos with 10 year lithium battery back up.

Supply and install new outdoor 150 amp Main breaker panel Convert old fuse panel into Junction box and nail shut and label as JUNCTION BOX Replace outdoor meter enclosure. Install new grounding system

1)----Check all outlets to see if plugs fit snug. 2)----Replace outlets(approximately 6)where plugs are loose and secure outlets that are loose against the wall.

Supply and install (1) regular thermostat Seal the supply plenum.

DINING ROOM- 1)-----Run low voltage wiring for dimmer to dining room light thru exisitng conduit. 2)-----Rewire dining room light to dimmer. 3)-----Install customer supplied low voltage dimmer and cover plate.

Garbage disposal not working

Remove and discard existing exhaust fan Install (1) customer supplied exhaust fan Replace (2) regular outlets Disconnect power to 1 electric box in music room.

GFI not working Extend circuit from existing electric receptacle to new switch box. Install (1) switch for garbage disposal.

Replace (1) AC Disconnect non-fuse

Supply and install (1) GFCI outlet in bathroom

1)-----Go through all outlets and switches and check for loose connections, dead shorts and bad devices---switches, outlets and breakers. FOUND: Dead short at outdoor GFI outlet and switch line wired incorrectly. REAPAIR INCLUDED: 1)-----Replaced GFI outlet and in use weather proof bubble cover. 2)-----Rewire switch line so switch to security light does not short out circuit. 3)-----Traced out switches and removed switches. 4)-----Installed blank plate.

Diagnosis level 1, outlet under sink got smoke Supply and install (1) surge protector for whole house

Main breaker tripped

Diagnose circuit not working

Install (3) indoor fixtures customer supplied where existing lights located

Diagnose 4 outlets not working

1)-----Remove exisitng landscape lighting time clock. 2)-----Install new customer supplied time clock and set to desired on/off times. 3)-----Install 1 whole house surge protector at each 200 amp main breaker disconnect for a total of 2.

1)-----Remove exisitng landscape lighting time clock. 2)-----Install new customer supplied time clock and set to desired on/off times. 3)-----Install 1 whole house surge protector at each 200 amp main breaker disconnect for a total of 2.

Replace (1) 150 amp outdoor panel