Delray Beach FL Electrician & AC Repair

Installation new 240v condensate pump

Darin line was not blown out on previous call Blew out drain line System is working

1 year AC red carpet club Perform 1st visit.

Replace (1) 35/3 mfd dual capacitor

1)——Remove existing pool panel and time clock attached to it. 2)——Install new 100 amp 8-16 circuit main lug outdoor panel for pool equipment. 3)——Supply and install new outdoor rated time clock. 4)——Run dedicated 100 amp circuit from outdoor main breaker panel to pool panel using 1 1/4 inch PVC. (Approximately 50ft) 5)——Install new whip to existing j-box with 1 40 amp dedicated circuit and 1 20 amp dedicated circuit. 6)——Install new whip from existing time clock to pool pump. 7)——Power up and ensure equipment is running properly. 8)——Remove time clock and outlet at side of home for landscape lighting. 9)——Install new weather proof junction box and GFI with in use bubble cover. 10)——Install new outdoor rated time clock.

1)——Install customer supplied sconce light fixture at front porch. 2)——Remove 2 post lights from front yard. 3)——Install 2 customer supplied post lights in front yard.(will need to cement posts into ground) 4)——Extend security light circuit using pvc at 3 locations to desired location of lights to be installed. 5)——Install weather proof junction box at each location for a total of 3. 6)——Supply and install 3 2 head LED motion detected security lights.

1)——Install GFI outlet in bathroom 1 and 2. 2)——Install 2 GFI outlets with in use bubble covers on back patio.

1)——Troubleshoot water heaters, make sure correct voltage is coming to both water heaters. 2)——Check GFI outlet connected to pumps at pond and make sure it is working properly. 3)——Troubleshoot path light; found loose wiring and bad bulbs. Tightened connection for temporary fix and replaced 2 bulbs. 4)——Replace ballast at master closet light. 5)——Replace switch for master closet light.

Install (1) ceiling fan customer supplied Install (2) toggle switches Note: 1 blade screw is missed, customer acknowledging that could lead to the fail of the fan blade. Recommend customer install the missing screw as soon as possible

Burnt marks are found at indoor panel. Breakers make bad connections. Panel is made by Federal Pacific which has been recalled by fire hazard. RECOMMEND: Replace (1) 150 amp indoor panel with GE panel. Replace (2) GFCI outlets in bathrooms Replace (2) outlets in kitchen which unable to hold the plug. 1 year warranty from Kings Permit fee will be passed through customer if requested

Change (5) 9v batteries

1)——Remove and replace 15 amp Cutler Hammer breaker. 2)——Remove and replace garage GFI outlet. 3)——Check fridge outlet for loose connections and confirm that its working correctly after replacing GFI outlet in garage.

Outlet in kitchen not working

Install (1) customer supplied fixture with 10ft concrete ceiling

Inspection

Diagnosis lights circuit tripped breaker, (10) fixtures and (2) switches needs to be inspected. Diagnosis (1) bar circuit breaker keep tripping Replace (2) timer switches customer supplied Extend 120v landscape wires from existing junction box. Wire needs to be ran inside underground conduit, approximately 25ft

Replace (1) outlet in dining room burnout causing breaker tripped

Extend (1) 15 amp extension cord to outdoor wall. Approximately 15ft Supply and install (1) GFCI outlet and bubble cover

Install customer supplied light Install Wire mold from existing outlet Install Wire mold extension box Permit fees for Sub Permit will be passed through to customer

1)——Remove 4 outdoor outlets/cover plates and 1 outdoor junction box. 2)——Install 1 new single gang weather proof junction box. 3)——Install 5 GFI outlets and weather proof in use bubble covers. 4)——Remove bathroom light fixture and install new customer supplied light fixture.

1)——Replace 15 amp circuit breaker for lighting circuit. NOTE; DAMAGED BREAKER COULD HAVE BEEN CAUSED BY IMPACT OF CAR HITTING GARAGE DOOR.

Supply and install (2) 4ft ballast. T8

Diagnosis AC not cooling Found: very low Freon in system and a low voltage wire was cap off. Tried bubble leak test at service valves but couldn’t detect the leaks. System is 13 years old, the leaks could be in evaporator coils or condenser coils. Recommend replace new system to avoid the cost for regularly adding Freon Add 3 lbs of Freon to get system run

Relocate (1) 100 amps 16 circuits indoor panel to new location. Convert existing panel housing as junction box. Supply and install (1) 100 amps 8/16 indoor panel at new location which customer agreed Replace 15ft cloth underrated wire feeders from outdoor panel to new indoor panel to match with capacity amp. Install (1) junction box in attic to extend short circuits to new panel $500 Permit fee passed through customer if requested Rough patch and clean area

Replace 3 ton AC split system with new high efficiency system. 10 years warranty from manufacturer and one year warranty from Kings Permit fee passed through if requested