Coconut Creek FL Electrician & AC Repair

Adding 2 lbs of refrigerant Vacuum the drain pan

1)——Remove plastic soffit, flourescent fixtures and basic light fixture from kitchen. 2)——Using the exisitng switch line, Supply and install 5 6 inch LED flat panel lights. 3)——Relocate exsitng outlet in kitchen on wall, up 3 ft and to the left 1 or 2 ft. 4)——Pull permit and get inspection.

Install ecobee smart thermostat without C wires

1)——Remove flourescent garage light fixture. 2)——Install customer supplied LED light fixture in garage. 3)——Remove and replace 4 way switch at top of stairwell.

AC inspection: Heating and cooling is working properly. Drain line is cleared. New battery for thermostat

1)——Extend electric from fixture box in living room and dining room to reach coffit ceiling. 2)——Install 100lb rated fixture box in coffit ceiling at both locations. 3)——Assemble and install chandelier at both locations. 4)——Supply and install LED rated dimmer at both locations.

Install customer supplied fan

1)——Remove and replace 125 amp main breaker.

1)——Remove 2 exisitng HIHATS in foyer with LED RETROFITS. 2)——Remove existing fixture box above stairwell. 3)——Relocate switch line of HIHATS to center box of cofitt ceiling and install 100 lb. rated chandelier fixture box. 4)——Assemble and install large customer supplied chandelier. 5)——Relocate switch line of stairwell fixture box to front and back boxes of cofitt ceiling. 6)——Install 2 new remodel 6 inch cut in HIHATS with existing LED RETROFITS. NOTE: Will need 25 ft scaffolding. CHANGE ORDER: 1)——Did not have to build scaffold.(Discount $200) 2)——Remove 4 LED fixtures in downstairs hallway. 3)——Supply and install 4 LED fixtures in downstairs hallway. 3)——Did not do demo.(Discount $322.50) 4)——Added 1 existing LED fixture and junction box in middle box of stairwell and at top of stairwell for a total of 2.

Diagnostic and repair on entire bathroom circuit not working Replace any and all affected devices Replace any bad breaker causing issue New wires would be an additional cost

Replace pool pump circuit breaker in disconnect box

1)-----Remove 3 outdoor outlets, 2 garage GFI outlets and cover plates. 2)-----Install 3 weather resistant outdoor outlets and 3 weather resistant in use bubble covers. 3)-----Install 2 weather resistant GFI outlets in garage. 4)-----Remove intercom door bell. 5)-----Add metal or plastic cover plate to cover hole where intercom door bell was. 6)-----Install new door bell button. 7)-----Install 15 customer supplied retrofit LED hihat trims at other property. (ADDRESS 4902) 8)-----Remove back patio intercom speaker. 9)-----Install new customer supplied intercom speaker.

Dedicate line for car charger 240v, 40amps branch circuit from indoor panel. Customer supplied outlet. Replace (1) regular switch for fan light Replace (1) fan control switch for the fan

UPSTAIRS GUEST BATHROOM- 1)-----Extend circuit from exisitng switch line to provide power to HIHATS to be installed. 2)-----Install 2 6 inch HIHATS with retro fit LED trims. MICROWAVE INSTALL AND VENT- 1)-----Remove exisitng microwave. 2)-----Drill hole through wall in back of microwave location. 3)-----Install duct on new microwave. 4)-----Install new microwave. 5)-----Install vent cover on exterior wall where microwave duct comes through wall. GARAGE EXHAUST FAN- 1)-----Remove exisitng 8 inch exhaust fan. 2)-----Supply and install new 8 inch exhaust fan and reconnect duct to fan.

1)-----Install 20 amp 110 volt whip at water heater. 2)-----Hook whip up to panel and install on 20 amp single pole dedicated breaker to water heater.

Supply and install (5) 3ft LED undercabinet lights Run Power from attic light circuit down entry wall from garage to kitchen for undercabinet lighting switch and install switch box Run 2 switch lines from switch box to each side of kitchen for undercabinet lights Supply and install (2) outlets at switch lines for under cabinet lighting Supply and install dimmer for UC lights Supply and install (2) circuits on outside wall with outlets and bubble covers for customer provided secruity cameras Supply and install (1) circuit on outside wall with outlet and bubble cover for TV Supply and install coax cable for TV Install (1) switch in bathroom Install (2) circuits for fans on outdoor purgala with switch leg running to inside of home Remove existing indoor 2 gang box and replace with 3 gang box in order to add 3rd switch for fans Supply and install (2) motion lights (black or dark brown) where existing fixtures are (approximately 20ft) Install (2) customer supplied LED light bulbs that need

Replace (1) regular outlet Diagnosis level 1 Outlets in kitchen are not working Install (1) bubble cover

Install outlet approx 6 inches above existing outlet Supply and install 5k LED hi hat fans and trims

Hang (1) fixture customer supplied. 10ft ceiling

DISHWASHER/DISPOSAL- 1)-----Remove exisitng junction box and outlet. 2)-----Reroute wiring to desired location under sink. 3)-----Reinstall junction box and outlet at new location. MICROWAVE CIRCUIT- 1)-----Run approximately 40 ft of 1/2 inch pvc conduit from outdoor main breaker circuit panel to desired location of microwave circuit. 2)-----Drill hole through wall at microwave location from exterior to interior. 3)-----Run conduit to interior. 4)-----Pull 20 amp circuit thru conduit. 5)-----Install junction box and 20 amp single outlet at microwave location.

Found correct voltage at disconnect, condensing unit and breaker. The contactor was vibrating and pulled in feeding the compressor and voltage was correct on both sides of contactor. The unit is intermittently coming on and cutting off. When unit is off, voltage is still correct at unit.

Supply and install (4) LED hi hats Install (2) LED hi hats (no existing) Install new switch leg for light over dining room fixture Hang customer supplied fixture Install 4ftx1ft LED troff light Install (1) switch leg for LED fixture over island

Supply and install new 15amp breaker

1)-----Remove fan. 2)-----Assemble and install customer supplied fixture.

Supply and install GFCI 1 year warranty