Pompano Beach FL Electrician & AC Repair

Hello Al, thank you for choosing Kings Electric with your electrical needs. Today we had the pleasure of troubleshooting your home electrical due to the fact that when certain appliance and units turn on the whole home experiences a voltage drop. We then opened up your panel and meter and concluded that with no load on the lines the voltage coming in from FPL were 110v and 120v. We believe that this misbalance of voltages is what’s causing your home to have power surges. Please reach out to FPL and have one of their techs come out and inspect their lines. It was a pleasure servicing you and we look forward to helping you out in the near future. Your Service Electrician Jeahn Bermudez

Supply and install wiring and fixtures for the following: 5 - Emergency dual head LED wall packs 3 - Emergency dual head combo exit and emergency LED lights 1 - Switch at new front man door to control warehouse lights. 1 - Switch at new front man door to control exterior egress lights (existing) 1 - dedicated GFCI circuit / receptacle for water cooler (by others) 2 - New lighting circuits for emergency lighting from existing panel. 4 - Quad-plex receptacles on front and back walls per tenant request. 2 - New circuits for receptacles from existing panel. Note: Permits, drawings and fees for this permit are included.

Replace (1) Light fixture customer supplied

Perform rcc

Perform rcc visit

Perform rcc

Perform rcc visit

Dear customer. We’re happy to give you the estimate to — Supply and replace (1) 15A receptacle — Extend power from existing power sources to install (1) 15A receptacle on ceiling for new garage opener — Diagnosis water heater tripped the breaker Thank you for choosing us and feel free to reach out for more details **********Jason - Kings Electric & AC**********

Replace double tapping in panel with two wafer 15 amp breaker‘s

Supply and install revised engineering for Bay 3 mechanical revisions due to new tenant occupancy requirements. New drawings to comply with new building plans submitted by others. New calculations based on the new occupancy load of 18 persons in a 4,500 sq. ft. space as per the new architectural drawings. Includes revised drawings, calculations, and schedules required by the building department.

Install new dedicated circuit from panel to washing machine outlet. Original circuit is comprised and tied in with outdoor GFCI

Remove existing electrical panel and replace with new. NOTE: patching & painting (if needed) by others. NOTE: permit not included.

Replace (1) 2 pole 20A outlet

Thermostat seems doesn’t work correctly. Recommend replace thermostat if happens again

Run Circuit extension from existing outlet with power to existing outlet that has lost power. -Install outdoor post head lamp

Both existing air conditioning units on the roof servicing the warehouse are past their useful life expectancy. Both units are 14 years old. The units use R-22 Freon which is outdated and no longer permitted. Not environmentally friendly. The units have metal condensate pans which are rusting and leaking. The coil in one of the units has a leak someplace and causes the system to freeze up then defrost causing water to leak through the ceiling. The other unit has a defective condenser fan motor causing the system to overheat and shut-off. Both units are old and compromised and should be replaced.

A) Warehouse Area * Replace existing 7.5-ton system located on warehouse area. Installation of one new 7.5-ton America standard RTU to match exist curb. * Including new motorized damper, programable thermostat and dual cut off safety overflow switch. * Installation of one new duct system for 7.5-ton system with minimum duct drop down and 5 grilles in the plenum. * Return drop down with screen mesh. * System will have included one smoke detector on supply side with key station. B) Office Area * Installation of one (1) new Goodman 5-ton RTU including new curb, electric heater, programable thermostat, motorized damper, PVC drain and dual cut off safety overflow switch. *System will be ducted to existing supply and return main lines going to east offices. We will add total of 3 return drops. Permits & Inspections included. NOTE: All roofing penetrations, repairs, engineering (if needed) by owner. NOTE: Subject to building department review and approval.

Supply and install one (1) new 200-amp, 3-phase, 120/240-volt, 42-ckt interior electrical panel with sub-metering device. Power to originate from the existing buss-duct system in bay #3. Remove three (3) existing 1-phase electrical panels in Bay #3 Identify the existing circuits from the office area in Bay #3 and re-circuit them to the new 200-amp electrical service. Provide all conduit, wire and junction boxes required to re-route the existing circuits to the new panel. Disconnect and cap-off all old office circuits no longer being used. Relocate wiring to "house lights" with timers from Bay #3 to Bay #2 electrical panel. Includes wiring to new RTU units on roof. Existing office wiring, fixtures, switches, etc., to remain "as-is". Subject to the final approval of the building department.

Warehouse Area * Supply and install one (1) 10-ton system located on warehouse area. Installation of one new 10-ton America standard RTU to match exist curb. * Including new motorized damper, programable thermostat and dual cut off safety overflow switch. * Installation of one new 50 linear ft. of horizontal duct system for 10-ton system with minimum duct drop down and 10 grills in the plenum. * Include 3-phase power wiring and electrical disconnect at unit. * Include low voltage wiring for thermostat. * Return drop down with screen mesh. * System will have included one smoke detector on supply side with key station. NOTE: All roofing penetrations, repairs, engineering (if needed) by owner. NOTE: Subject to building department review and approval.

Supply and install one (1) new 200-amp, 3-phase, 120/240-volt, 42-ckt interior electrical panel with sub-metering device. Power to originate from the existing buss-duct system in bay #2. Identify the existing circuits from the office area in Bay #1 and re-circuit them to the new 200-amp electrical service. Provide all conduit, wire and junction boxes required to re-route the existing circuits to the new panel. Disconnect and cap-off all old office circuits no longer being used. Includes wiring to new RTU units on roof. Existing office wiring, fixtures, switches, etc, to remain "as-is". Subject to the final approval of the building department.

Dear customer. We’re happy to give you the estimate to correct the issues that has been addressed on inspection report — Replace (1) open neutral combo switch-outlet by 2 separate switch and GFCI outlet in master bathroom — Remove the regular outlet and repair wiring issues in 2nd bathroom. — Diagnosis (3) outlet in two different areas (guest bedroom and dining room) don’t have power, not including run new wires if they are interrupted — Repair (1) open ground outlet in garage conversion room — Add pool pump switch and install bubble cover — Run new ground wire inside the conduit for pool pump, gas line and water pipe Thank you for choosing us and feel free to reach out for more details **********Jason - Kings Electric & AC**********

Upon arrival noticed two units with no power. Turn breaker at buss duct electric panel & units kicked on. Package unit running but in bad shape evaporate coil is dirty and has dust everywhere it also needs at AX35 belt a coil cleaning also system on cooling 2nd stage . For existing split system 7 ton in Bay #2 Unit slight under charged charged two lbs of 410 unit now has subcool of 12 degree . Completed check unit is cooling will need adjustment with returns since we eliminated Bay #1 ductwork to separate system. Also survey Bay #1 curb and a/h possible location & where we will cut in roof jack and stand.

WO 201113-00272 Problem: AC unit C-1 is not cooling. Temperature reads 86 ( please check all units in C building for proper operations) Make : Carrier Model : FA4CNC048 Serial : 0307A87748 Type : Air Handler Make : Carrier Model :38CKC047300 Serial : 3301E15141 Type : Condenser Tech Notes : Found outdoor unit not running . Upon further inspection found run cap with bad mfd. Replaced run cap 50mfd and added 3 lbs of 422d replacement. Unit are in bad shape but still functioning at this time. Bad filters as well 22x22 x1 . Other unit are running accordingly at this time Solution : Replaced 50mfd Capacitor and added 3 lbs of 422d replacement gas. Replaced Filter. Checked all other units. All other units are working well.

One of the compressor is low on freon. Need add 3 lbs of R22 replacement refrigerant Recommend add leak stopper due to the corrosion on copper lines to seal the leak if possible Total amount will be deducted toward new AC replacement

Replace (1) 2 ton AC split system with new high efficiency system. 10 years warranty from manufacturer and one year warranty from Kings Permit fees Included