Local Electrician | Broward, Palm Beach, Orange County and Seminole Counties

Dispatch fee

Replace (1) 50 amps breaker for AC condenser

Perform AC maintenance visit Clean clogged drain line Recommend new drain line

Install conduit to protect power cord for water heater Diagnosis lights and ceiling fans at patio not working. Not including wire being interrupted inside the conduit

Supply and install (2) locking caps for service valves

Wireless doorbell not working properly Clean up the battery connector inside the remote to make good connection

Perform 1st red carpet club for AC. Clean drain line, check evaporator coils, change filter, check Freon pressure, clean condenser coil. Replace (1) 1 year UV light bulb

Install (2) dimmer switches and (1) regular switch customer supplied Supply and install (1) GFCI outlet with bubble cover for outdoor receptacle Install fixture cover customer supplied

Hook up dryer outler 4 prongs

Supply and install new 2 ton rheem split system Supply and install new hurricane tie down straps on outdoor unit 10 year warranty on parts from manufacturer from rheem 1 year labor warranty with kings 1 year RCC ac maintenance with Kings Permit fees will be passed through if needed.

1)——Remove 50 amp 3 prong outlet at oven shelf. 2)——Install proper metal deep junction box connected to exisitng oven circuit. 3)——Remove 50 amp breaker at panel and install properly sized 30 amp breaker for oven. 4)——Harwire oven to exsitng oven circuit.

Install new timer box outside for sprinkler Install new line for new motion light in front of home Relocate existing motion light on back of house Replace 200 indoor panel 40/20 circuit Rejuvenate outdoor panel including: clean inside panel, check and tighten all connection, replace circuit breakers, upgrade grounding system Install whole house surge protector Permit fee will be passed through if needed

1)——Disconnect generator circuit from 2 pole breaker in panel. 2)——Run dedicated 30 amp circuit to right below panel and install junction box with customer supplied 4 prong 30 amp outlet and cover plate.

Customer will try a handy man to replace socket first

Upgrade indoor panel to 200 amps service Upgrade outdoor panel to 200 amps service Upgrade aluminum feeder wires from outdoor panel to indoor panel and meter to outdoor panel as well to 2/0 gauge copper. Replace feeder conduit to 2 inches PVC. Approximately 30ft. Upgrade grounding system with 2 ground rods and water pipe grounded. Remove AC sub-panel burnout and extend wires into new panel. Supply and install whole house surge protector 1 year AC red carpet club. Permit fee will pass through if needed

1)——Remove 200 amp min lug indoor circuit panel. 2)——Install new 200 amp main lug indoor 40 circuit panel. 3)——Label, rough patch and clean.

Supply and install Generator clip on outdoor panel Supply and install Generator 50amp outlet on outside of home Supply and install new 50amp 2P SQD Breaker in outdoor Panel

1)——Remove 250 AMP meter enclosure and 2 125 amp main breaker disconnects. 2)——Install new 320 amp meter enclosure and repair rusted feeder pipe connected to bottom. 3)——Install 2 new 150 amp 8/16 circuit mainbreaker feed thru panels. 4)——UPDATE GROUNDING; install 2 ground rods, 1 water pipe ground and 1 low voltage ground bridge interconnected with #2 gauge copper wire. 5)——Arrange emergency disconnect/reconnect with FPL. 6)——PULL PERMIT AND GET INSPECTION.

Install customer supplied nest thermostat. Has C wire

Replace (1) 40 amps 2 poles breaker

1)——Remove 200 amp outdoor main breaker circuit panel. 2)——Install new 200 amp outdoor Siemens main breaker 8/16 circuit feed thru panel. 3)——Update grounding system; install 2 new ground rods, 1 water pipe ground and 1 low voltage ground bridge interconnected with #4 gauge bare copper wire. 4)——Remove 200 amp indoor main lug circuit panel. 5)——Install new 200 amp indoor Siemens main lug 20/40 circuit panel. 6)——Label, rough patch and clean area. 7)——Pull permit and get inspection.

Dispatch fee. Front door switch controls garage circuit.

Replace existing 3.0 ton split AC system and replace duct work in attic space. Relocate and raise air handler in attic due to ceiling reconfiguration. Relocate the existing outdoor condensing unit away from under the electrical meter. Supply new slab and extend the electrical and copper lines. Remove existing duct work in attic space and replace with new flex-duct system.

Replace (6) existing plenum outlets with (6) new can outlets. Reuse existing flex ducts

Gave estimae for outlets and generator