Local Electrician | Broward, Palm Beach, Orange County and Seminole Counties

Diagnosis and repair lights and outlets not working at multiple areas Not including run new wires if they are interrupted

Diagnosis (1) burned wire at 20A breaker (#10) Repair by replacing a part of the damaged wire

Dear customer. We’re happy to give you the estimate to install motion light fixtures around your house — Supply and install (4) motion light fixtures at 4 corners of the house — Remove (1) smoke detector in kitchen and cap-off the electrical box

Diagnosis and repair kitchen and dining room lights not working Not including run new wires if they are interrupted

Replace (2) dimmer switches

Lock Freon and disconnect copper lines Remove evaporator coil and clean outside with chemicals Reinstall and connect copper lines Add Freon if needed

Diagnosis and repair outdoor outlet not working

Remove existing wires from yard. Run new circuit using UF cable to desired locations for (2) new gfci outlets in yard. Install (2) boxes at desired location for GFCIs

Supply and install (1) LED motion light fixture

Install customer supplied fixture in utility room

After observing the panel. The bus bar was replaced. The panel itself has not been. Burnt spots on the panel are from previous electrical spark. Since then panel bus bar has been replaced.

Hello Maria! There were 2 lamps that are malfunctioning due to bad ballasts. We replaced all ballasts within the fixtures and got all lamps lit up and functional. It was a pleasure servicing you and we look forward to helping you out again. Thank you for trusting in Kings Electric and AC . Your Service Technician Jeahn B

Install (1) exhaust fan customer supplied

Warranty

Warranty bad AC breaker

Replace (1) 20A double breaker Re-wire range circuit

Replace (2) T12 40 ballasts

Replace (1) LED fixture in garage

Loose neutral wires in the box

Repair (1) double tapping breaker

Warranty l recommend cut-out coil cleaning if the problem occurs again

Diagnosis breaker tripped in living Found burnt out outdoor outlet Need to run new wires and install new GFCI outlet and bubble cover Remove outlet, Cap-off the wires and install blank cover as customer requested

Update duct work going to exhaust fans up to code.

— Remove (2) fluorescent lighting fixtures — Illuminate (1) light circuit — Relocate and Extend wall light circuit to (2) electrical boxes where new vanity light fixtures will be installed — Install (2) vanity fixtures customer supplied — Hard wire hot water heater for safety Customer is responsible for patching and painting

Perform rcc visit